Anti Mould Aerosol

Ronseal Anti Mould Aerosol

Our 6 Year Anti Mould Aerosol only takes 10 minutes to dry and gets into all those hard to reach places. You'll need to put on 2-3 coats but there are no brushes to clean up when you're done. 

Before You Start

Make sure your room is above 10°c. Open your doors and windows for ventilation. Put down dust sheets to protects anything you don't want to get paint on and mask the surrounding areas to avoid overspray. 

Prep - Newly plastered walls: If you've had your walls and ceilings plastered, leave it to dry for 7 days. Then seal it before putting on our Anti Mould Paint.  

Prep – Previously painted walls: Get rid of any loose paint or plaster by giving it a quick sand. If you've already got mould, get rid of it by using our 3in1 Mould Killer. 

Using Your Aerosol

Shake the can until you hear it rattle, then keep going for 1 minute. Hold the can upright, 20-30cm away from the wall or ceiling and spray from side to side to get an even finish. Put on 2-3 coats, leaving 10 minutes between each coat. After your last coat leave it 24 hours before letting condensation build up in the room. Don't paint over our Anti Mould Paint with anything else. This stops it working. 

Usage Areas: All indoor walls and ceilings.
Compatibility: Bare and previously painted walls and ceilings. 
Clean Up: Hold the can upside down and spray for a few seconds. Then wipe the nozzle with a damp cloth.