For Garden

Total Wood Preserver

Description

Traditional, solvent based preserver. Prevents against rot, decay and wood discolouring funghi. It'll also protects against woodworm attack. Use biocides safely. Always read the label and product information before use.

  • Long lasting protection
  • Prevents rot, decay and woodworm attack
  • Solvent based
  • For exterior wood
  • Available in clear & coloured
Coverage Calculator

How much do I need?

Measure your area precisely, drop the numbers into this smart calculator and it will tell you straight away how many litres you'll need to complete your project.

Area Height
Area Width
Use on the following wood types
  • Exterior wood
    Exterior wood

5 colours available including:

Black

Clear

Dark Brown

Green

Light Brown

How to use Total Wood Preserver

Before you start

Make sure the wood is clean and dry and free from any paint, varnish or stain. Shake well before use and test on a small area to check that you're happy with the colour.

Application

You can either brush, spray it on or dip apply. For the end grains, we’d recommend dipping to make sure the preserver completely soaks into the wood. Apply at least 3 coats, waiting 24 hours between them. If you need to carry out any repairs or gluing, wait until the second coat is completely dry.

Clean Up

Remove any preserver from your brush and wash in white spirit. Don't put any left over preserver down the drain or into watercourses. Your local authority may have facilities to get rid of unused preserver.

Identifying rot

Dry rot

Dry rot might appear as white, cotton wool like growths or in white, grey sheets. You may also find white or grey branching strands, up to 6mm wide spreading on brickwork or behind plaster. Rusty red, pancake shaped, fruit bodies can also mean that you have a dry rot problem. Wood under attack from dry rot shrinks and splits in large brick shaped pieces across the grain and is dry and brittle.

Wet rot

Wet rot is a fungal attack and can cause the surface of the wood to darken. Decayed wood splits along the grain and smaller cubes of wood are formed as a result. The wood may also become soft and spongy. Thin, brown branching strands of fungi may form on the surface of the timber under attack.

Insect attack

Insect attack can be recognised by small, round flight holes on the surface of the wood or by tunnels in the wood. New holes will show clean, fresh timber inside them and fine, gritty powder can be seen on the surface or beneath the site of activity.

BBA approved