Precision Finish Fence Sprayer
Our Precision Finish Fence Sprayer accurately treats a fence panel in less than 3 minutes. It’s got two spray width settings for accuracy and speed, making it easy to do the hard to reach bits as well as filling in large areas.
- Two spray settings for accuracy and speed
- Ready to use
- Funnel neck for easy filling and decanting
- Solid base with foot rest for stability when pumping
- Clear indicator to see fill level in sprayer
It takes no time at all
Ronseal Precision Finish Fence Sprayer
Before You Start
Before you start, make sure it’s a warm dry day. Then mask off any areas that you don’t want to spray. Don’t spray in windy weather otherwise you could end up spraying more than just your fence.
Using Your Sprayer
Use with either Ronseal One Coat or Fencelife Plus+. If it’s not sprayable or if it’s solvent, don’t put it in the sprayer, as it won’t work.
Push down the handle of the sprayer and rotate anti-clockwise until the pump pulls out. Pour the Ronseal Sprayable liquid into the sprayer tank. Once filled, screw the pump back in and turn the handle clock-wise. Make sure it's tight.
Place the unit on a flat surface to ensure stability and begin pumping the handle up and down. Pressurise the sprayer until the pressure release valve opens, a slight hissing noise should be heard.
Make sure the nozzle is around 25cm away from the fence. Use long sweeping arm movements rather than short wrist movements. When moving down the fence overlap part of your previous pass by 50%, this’ll make sure the whole area is covered with the correct amount of product.
1. Clean up
To empty the sprayer, push the pump handle all the way down and lift the pressure release valve until no ‘hissing’
can be heard. Once the pressure has escaped, unscrew the pump unit and tip any liquid back into its tub.
(Alternatively, spray the excess liquid back into its tub before releasing pressure).
Remove as much product as possible before cleaning, some local authorities have special facilities for the disposal of waste coatings. Don’t empty into drains or watercourses. It’s important that the sprayer is cleaned thoroughly after use. Don’t leave the sprayer filled with product when not in use or overnight.
Rinse out the sprayer several times with clean water, then refill with clean water. Re-pressurise and then spray through the nozzle until the water runs clear, it’s best to do this on the Speed setting.
2. Cleaning the wand filter
Unscrew the wand handle from the trigger and clean the filter with clean water.
3. Cleaning the nozzle and nozzle filter
Remove the nozzle and white filter and clean with warm, soapy water and an old toothbrush. Make sure you don’t use a sharp object as this will damage the nozzle and ruin the spray pattern. Put the nozzle back together and take care to do this in the correct order